RC Helicopters Cars

Thierry Mobile :

+33 (0)7 87 30 23 97

Pas de sms, ni messages


Pour toutes demandes, conseils, suivis, SAV :



CopterX Racer 250 RTF Devo 10+valise alu

329.9 EUR

Racer 250 RTF avec radio Walkera DEVO 10, RX 601 Walkera, camera, retour d'image.

Manque plus que la batterie et les lunettes (ou un écran)...

 Fourni en valise aluminium.

Racing Drone Specification:

  • Body frame thickness: 1.6mm
  • Motor arm thickness: 4mm
  • Wheelbase: 280mm
  • Propeller: 5" or 6"
  • Weight: 636g(battery included)
  • Dimension: 222*245*87mm 

CC3D Features:

  • Applicability to all types of aircraft, helicopters and multirotors
  • Powerful Cortex-M3 32 bit ARM 72MHz (512 KB Flash, 64 KB RAM) processor
  • 8 standard RC PWM inputs from any RC receiver (no adapter)
  • 12-channel PPM input (all channels in one signal)
  • Support for serial protocol/JR Spektrum remote satellite receivers via the OpenPilot Spectrum Adapter
  • Full native support for Futaba, S-Bus Protocol (up to 18 channels, regardless of the number of physical outputs at receiver)
  • 8 standard (PWM) outputs for servo and/or regulators (does not require any adapters)
  • TurboPWM mode (from 50 to 450Gc) for regulators and digital servo
  • I2C support for I2C devices, sensors, etc
  • Built-in support for microSD cards up to 32 GB (or more) to store configuration and logs
  • Selected non-volatile flash memory for settings. If there is a problem with the SD card it will not affect the operation of the system
  • OpenPilot V8 GPS support, as well as any other GPS receivers 1-10 Hz or more with NMEA protocol
  • Built-in support for USB (no driver needed) and serial port for connecting telemetry
  • Support for generic UAVTalk protocol to communicate with the GCS
  • Full read/write from the GCS to all settings and data from the system both on the ground and in-flight
  • An embedded python interpreter for programming of flight plans and other custom features
  • Support firmware update via USB, serial channel and via radio modems
  • The boards have an OpenPilot standard size of 36x36mm. Some connectors may protrude slightly for ease of access 

700TVL FPV camera Specification:

  • Type: color
  • Pick up device: 1/3" SONY Super HAD CCD
  • Signal system: NTSC: 60Hz / PAL: 50Hz
  • Effective pixel: NTSC: 510(H)*492(V) / PAL: 500(H)*582(V)
  • H.Recolurtion: 700TVL
  • Sensitivity: 1.0Lux F1.2
  • S/N ratio: >48dB
  • Gamma: Y=0.45/r=1
  • Video output: 1Vp-p 75Ω
  • Electro shutter: 1/50, 1/60-1/100,000sec, Automatic
  • Current: 120mA
  • Power: 12V DC regulated ±50%
  • Storage temperature: -20°C - +60°C
  • Weight: 96g
  • Box dimension: 98*68*58mm 


RX601 Specification:

  • Type: 2.4GHz 6 channels
  • Sensitivity: -105dbm
  • Frequency interval: ≥4M
  • Weight: 5g
  • Receiver battery: 4.8V-6V 1300mAh
  • Dimension: 33*20*13mm 


TS5823 5.8G FPV transmitter Features:

  • 32 channels: Cover A, B, E bands and F bands
  • Micro sized and light weight
  • Transmitter frequency: 5645-5945MHz with 200mW power output
  • Transmitting distance > ~1500m (open area)

TS5823 5.8G FPV transmitter Specification:

  • Modulate: Wideband FM Modulate
  • Video Format: NTSC/PAL
  • Output Impedance: 50 Ohm
  • Output Power: 23-24dBm
  • Channel: 32 CH
  • Operating Voltage: 7V-24V
  • Supply Current: 190mA
  • Operating Temperature: -10~85 Video Band Width : 0~8.0 MHz
  • Audio Carrier Frequency: 6.5 MHz
  • Video Input Level: 0.8~1.2 Vp-p
  • Video Input Impedance: 75 Ohm
  • Audio Input Level: 0.5~2.0 Vp-p
  • Audio Input Impedance: 10K Ohm
  • Connector: SMA Female
  • Antenna connection: SMA Male
  • Dimension: 40mm x 23mm x 8mm
  • Weight: 8g (without antenna)

EMAX MT2204 brushless motor Features:

  • Low CG deisgn, decreasing vibration whe motor runs
  • Light weight built
  • Longer duration of flight
  • Designed for mini multicopters, better flight performance
  • CW and CCW propeller adapters included, holding the propellers tight
  • 100% balanced, decreasing vibration to the minimum

EMAX MT2204 brushless motor Specification:

  • KV: 2300kv
  • Max. thrust: 440g
  • Number of cell: 2-3s
  • Framework: 12N14P
  • Propeller: 5"-6"
  • Length: 32.2mm
  • Weight: 25g
  • Shaft: 3mm
  • Diameter: 27.9mm

EMAX 6030 propeller Specification:

  • Size: 6.0*3.0inch
  • Shaft: 5mm
  • Weight (pair): 5g

EMAX 12A ESC Features:

  • Based on SimonK firmware, further optimized to the perfect drive performance and can be flashed with Blheli firmware
  • Quicker throttle response and better throttle linear
  • Low-voltage protection, over-heat protection and self-check functions
  • Separate power supply for MCU and BEC, enhancing the ESC's ability of eliminating magnetic interference
  • Parameters of the ESC can be set via program card or transmitter
  • Throttle range can be set to be compatible with different receivers
  • Equipped with built-in linear BEC or switch BEC
  • Max. speed: 210,000rpm for 2-pole, 70,000rpm for 6-pole, 35,000rpm for 12-pole

EMAX 12A ESC Specification:

  • Continuous current: 12A
  • Burst current (10S): 15A
  • Li-xx battery(cell): 2-3
  • BEC mode: Linear
  • BEC output: 1A/5V
  • Programmable: yes
  • Weight: 9g (wires included)
  • Dimension: 25*20*7mm

T10 1206 8SMD LED Features:

  • High quality and super bright LED bulbs
  • Easy to use, low power consumption
  • Designed with flexible and durable strip
  • No delay in lighting, much safer, prevent the rear-end collision danger
  • Transparent when not in use
  • Simple to install and clean
  • Functional and durable
  • Adopt big and stable chip
  • Twinkling, smooth and high-brightness
  • Easy to bend the shape as you like

T10 1206 8SMD LED Specification:

  • Number of bulbs: 8pcs
  • Color: white
  • Power: 1.5W
  • Interface: T10 flat port (socket width is 10mm)
  • Working voltage: DC12V
  • Working current: 350MA
  • Weight: 3g
  • Dimension: Ø12*16.5mm

Package Included:

  • CX250 Racing Drone frame kit
  • WALKERA DEVO 7 /10 transmitter
  • WALKERA RX601 receiver
  • OpenPilot CC3D flight controller
  • 700TVL FPV camera
  • TS5823 5.8G FPV transmitter
  • EMAX MT2204 2300KV brushless motor * 4 (CW*2, CCW*2)
  • EMAX 6030 propeller * 4 (CW*2, CCW*2)
  • EMAX Simon Series 12A ESC * 4
  • T10 1206 8SMD LED * 4